Direct Color Systems Directjet 1014UV Technical Information PDF herunterladen (Seite 24)

Maintenance

Go to table of contents

DCS_Direct_Jet_1024UV_1014UV_Maintenance_Troubleshooting_Guide_2.1.docx 24 | Page

Check head height

Remove the tool. Press the down arrow button and hold it until the elevator stops, then

release it. This sets the print head height.

Using and the arrow buttons once again, move the table until it is under the print

head.

If you have a standard drive, you can push the table with your hand at a slow speed. Do not

manually push the table if you have a direct drive.

Slide the DCS Head Height Gauge between the Print Head and the Media Table. It should fit

all the way under the head, with very little gap (just enough to slide a piece of paper in

between. Move the head to another point on the axis and check again. Check in several

places. If there is any significant difference at any of these points, contact DCS Tech

Support for adjustment information. If the head height needs adjustment, go to page 25.

Otherwise, if the head is at the proper height, stack the two guides and check the height of

the UV lamp using the same method. If the lamp height needs adjustment, go to page 26.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 38 39

Keine Kommentare

Direct Color Systems Directjet 1014UV Technical Information Seite 24